8
1.5
/ IP ADDRESS
USER GUIDE FOR LEGRAND DU
AL
B
AND WIRELESS A
CCESS POINT
AP Name
This name will help you to identify your
Access Point.
Allow management access on VLAN
All management/configuration access to the
AP can be restricted to a specific VLAN on
the uplink port.
By default, VLANs are disabled, and access
to the management interface is allowed from
any interface.
If needed, one VLAN on the uplink port can
be selected as the only way to access the
management interface (VLANs must first be
enabled to do so, see the Ethernet Interface
section).
Note:
if VLANs are enabled you can restrict
management/configuration access to a
specific VLAN ID or to the native VLAN.
Dynamically retrieve an IP address (DHCP)
You can either use Dynamic (DHCP) or Static
(use the following IP address) IP addressing
for the AP management.
By default or after a full reset, the Access
Point is set to use DHCP.
Enable AUTO-IP
If Enable Auto-IP is checked, the AP will fall
back to Auto-IP addressing mode
(169.254.0.0/16) if no DHCP server can be
found on the network.
Use the following IP address
(An IP address must be unique in your
network.
Netmask, Default Gateway and
DNS Server,
values can be safely copied
from a computer already configured with static
IP addressing in your network)
IP Address:
Type in the static IP address for
your Access Point.
Netmask:
Type in the IP Netmask for your
network.
Default Gateway:
Type in the default
gateway IP address (used for any traffic
beyond the local network).
DNS Server:
Type in your DNS IP address
(optional).
After changing settings on this page, click the
Apply
button to validate your changes and
click the
Save
button to keep your changes
for future reboots.