Introduction
The Access Point’s Back Panel
The Access Point’s port (where an uplink
network cable is connected) is located on the
Access Point’s back panel, the power is
supplied by power over Ethernet (802.3af
standard).
The Access Point’s Front Panel
User port:
This
LAN
(Local Area Network
100 base T) port allows to connect other
Ethernet network devices, such as a
computer, a hub, switch, router, printer, etc.
Reset Button:
This button has two uses:
Short press will reboot the AP
Long press (more than 5 seconds) will reset
the AP to its factory defaults (blue Leds will
flash)
Green Power LED
: The Power LED lights up
when the Access Point is powered on.
Blue Radio LEDs:
The radio LED light up
when the radio is active.
