Installation Instructions
RMF3/RMT3/RLF3/RLT3
15
Attaching Screen to Wall Mount
NOTE:
NEVER place both interface brackets (S and T or U and
V) to one side of the wall mount center line! (See Figure
13)
NOTE:
Do NOT allow both interface brackets (S and T or U and
V) to be located on same side of wall bracket. (See
Figure 13)
Figure 13
1.
Hang screen onto the top rail of the mount (W/X). (See
Figure 14)
•
RMF3/RLF3:
Hang top hook of interface brackets (S and
T) onto the top rail of the mount (W/X). (See Figure 14)
•
RMT3/RLT3:
Hang top hook of interface brackets (U and
V) onto the top rail of the mount (W/X). (See Figure 14)
NOTE:
The screen initially installs into the "service mode" to
allow easy cable access.
2.
Adjust screen and rails to desired viewing position.
3.
Route cables between wall and rails.
CAUTION:
PINCH POINTS! Keep fingers, hands and
cables out of pinch point areas.
4.
Pull downward on the pull cords and swing inward toward
wall, latching interface brackets to lower rail and fastening
bottom of screen to the mount. (See Figure 14)
5.
Attach end of pull cord (a magnet) to mount so it does not
extend beyond bottom of screen. (See Figure 14)
Figure 14
Adjustments
Horizontal adjustment
1.
The mount wall brackets may be adjusted side to side at the
point of attachment. (See Figure 15)
Figure 15
2.
The screen may also be adjusted along rails side to side.
NOTE:
NEVER place both interface brackets (S and T or U and
V) to one side of the wall mount center line! (See Figure
13)
NOTE:
Do NOT allow both interface brackets (S and T or U and
V) to be located on same side of wall bracket. (See
Figure 13)
NEVER place both interface brackets to one
side of the wall mount center line (CL)!
Center Line (CL)
[Brackets U and V shown]
(RLT3 shown)
1
Pull cords
4
4
Top hook
5
(RLT3 shown)
[Brackets U and V shown]
1" (25.4mm) horizontal
1
adjustment possible
1
