RMF3/RMT3/RLF3/RLT3
Installation Instructions
12
1.
Identify desired mounting location on wall.
2.
Align mounting holes in mount with studs making sure
mounting holes are centered on studs.
3.
Mark location of four mounting holes on wall.(See Figure 2)
4.
Drill four 1/2" holes.
5.
Hold metal channel on anchor flat alongside plastic straps
and slide channel through hole. (See Figure 4)
Figure 4
6.
Holding plastic straps on anchor, pull anchor away from wall
until channel rests flush behind wall making sure anchor
channel is positioned vertically on stud. (See Figure 5)
7.
Slide plastic cap on anchor towards wall until flange of cap
is flush with wall. (See Figure 5)
Figure 5
8.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 6)
9.
Repeat Steps 5 through 8 for each mounting hole.
Figure 6
10. Place mount over anchors and align mounting holes in
display mount with holes in anchors. (See Figure 7)
11. Place 1/4" flat washer onto 1/4-20 x 1-3/4" Phillips pan head
screw.
12. Insert Phillips pan head screw with flat washer through
mounting hole in wall mount and into anchor and tighten
until flush against mount. DO NOT overtighten! (See Figure
7)
13. Repeat steps 10 through 12 for remaining mounting holes.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
Figure 7
(N)
Drywall
Plastic Straps
5
Plastic Cap
Steel Stud
Drywall
Anchor Metal Channel
SIDE VIEW
(N)
6
7
Plastic Straps
Steel Stud
Drywall
Anchor Metal Channel
Plastic Cap
SIDE VIEW
8
Steel Stud
Drywall
Anchor Metal Channel
Mounting hole
SIDE VIEW
(M) x 4
(L) x 4
12
Screwdriver
