Installation Instructions
LF49/50/55UxP, LF49/50/55UxP-B2B
13
Attaching Flat Panel
NOTE:
Use the key to unlock and open the swing door.
1.
Use a 5/16" open end wrench to remove display frame from
kiosk swing door by removing and
SAVING
four hex head
screws. (See Figure 6)
Figure 6
2.
Clean the inside edge of the swing door (approximately one
inch depth around entire opening) with an alcohol wipe or
something similar, and let dry. (See Figure 7)
3.
Install gasket strip (D) around inside edge of swing door
opening. (See Figure 7)
NOTE:
Do not install gasket strip right up to edge. The gasket
strip should be placed approximately 1/16" away from
opening.
Figure 7
4.
Carefully place flat panel face down on a soft, non-abrasive
surface.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display. Properly sized
screws will easily and completely thread into display
mounting holes. If spacers are required, be sure to use longer
screws of the same diameter.
5.
Select screw
diameter
by examining hardware (BA-BL) and
comparing with mounting holes on flat panel.
6.
Select spacers:
•
Spacers are
NOT
required if mounting holes are not
recessed and display frame can lay flat against flat
panel.
•
Spacers (BM, BN)
ARE
required if mounting holes are
recessed, or if protrusions prevent display frame from
laying flat.
•
Spacers may also be used between the display frame
and flat panel to create more space for AV
components, or to accommodate thinner flat panels.
7.
Select screw
length:
•
By hand, insert SHORTEST length screw of selected
diameter (BA, BD, BG, or BJ) through universal washer
(BO--if required), display frame, spacer (BM, BN--if
required), into flat panel mounting hole. Do NOT thread
screw into hole at this time.
1
1
x 2
1
x 2
Display
frame
[LF49/50/55UxP shown as example]
3
(D)
Swing
Leave approximately
1/16" space between
edge of opening
and gasket strip
door
(D) Gasket strip
[View of swing door - inside]
