112
Parameter
Function
Channel
It is the monitor channel.
Snapshot mode There are two modes: Timing and activation.
Frame rate
You can select from the dropdown list. The value ranges from 1f / s to 7f / s.
Resolution
You can select from the dropdown list.
For 16 series DVR:
Channel 1 and channel 9 supports D1 / CIF / QCIF.
Channel 2 to channel 8, channel 10 to channel 16 supports CIF / QCIF.
Quality
You can select from the dropdown list. Here is for you to set video quality.
There are six options: 10%, 30%, 50%, 60%, 80%, 100%.
100% is the best quality.
Abnormity
The abnormity interface is shown as below.
Parameter
Function
Event Type
The abnormal events include: no disk, no space, disk error, net error.
You need to draw a circle to enable this function.
Activate the function by selecting
it from the drop down menu on the right.
Alarm Out
The corresponding alarm activation output channel when alarm occurs, There are six
channels.
Latch
The alarm output can delay for the specified time after alarm stops. Then system disa-
bles alarm and corresponding activation output.
The value ranges from 10s to 300s.
Send email
If you enable this function, system can send out email to alarm the specified user.
Alarm upload
System can upload the alarm signal to the network (includes the alarm centre.)
Show message
System can display alarm information in local DVR screen.