4/11
Technical data sheet: S000082102EN-1
Updated: 08/10/2013
Created: 08/10/2013
Cat. No(s): 0 625 14/24/54/64/74
Kickspot Self-testing/AutoDiag
self-contained emergency lighting unit
2. INSTALLATION (CONTINUED)
3. CONNECTION
2.5 Assembling emergency lighting units
Cat. Nos. 0 625 14/24/54/74
1
Insert the labels in the label holder.
Once pushed in as far as it will go, the pictogram holder orientation can
be adjusted by tilting it back slightly.
Remove the label from the unit (only for
SELF-CONTAINED EMERGENCY
EVACUATION LIGHTING UNIT
Cat. Nos. 0 625 14/24/54/74)
2
Insert the label holder in the cover plate.
CLICK
1) Position the ring with the label holder on
the unit by lining up the 2 marks opposite one
another.
3
Fix the assembly on the unit.
2) Lock with
a 1/4 turn.
1
2
3.1 Connecting the mains power to the self-contained units
Art. EC 12 § 3 of the safety regulations.
The branch supplying a unit must be joined upstream of the protection
device and downstream of the normal lighting control device for the
room or exit route where the unit is installed.
The polarity of the remote control may not be followed on this lighting
unit if a Legrand remote control Cat. No. 0 039 00 or 0 039 01 is used.
If another remote control is used, the polarity must be followed when
wiring, and the switch-on or switch-off command must be maintained
for at least 2 seconds.
Self-contained emergency lighting units + home lighting units
and reinforced emergency lights must be always wired to a remote
control 0 039 00.
The branch can be joined in the
electrical cabinet, on the switch
or in a junction box.
The power supply to the units is
subject to the same rules as the
luminaires (normal wiring).
