7/9
Technical data sheet: S000105459EN-2
Updated: 25/02/2021
Created: 05/12/2018
Microwave detector - DALI/DSI dimming
Cat. No(s): 0 489 55/56/57
CONTENTS
7. SETTINGS (CONTINUED)
Parameter
Default
value
Value after
initialisation
Range/
option
Description
General parameters (continued)
Lux Off level
999
225
1-950,
999: disabled
Sets a maximum light level above which the PIR sensor is disabled, preventing the
lights from being turned on by movement.
Lux On time
0
-
0 to 99
minutes
When the ambient light drops below the Lux On Level, this is the delay before
the lights come on. If at any time during the timed delay the Lux level position
is reversed, the process is cancelled. A minimum time of 15 seconds is defined
for a value of 0. If you try to turn on the lights using a manual control, the lights
will come on regardless of the ambient light level. However, if there is sufficient
ambient light, they will turn off again after the Lux Off time.
Lux Off time
0
1
0 to 99
minutes
When the ambient light exceeds the Lux Off Level, this is the delay before the lights
go out. If at any time during the timed delay the Lux level position is reversed, the
process is cancelled. A minimum time of approximately 15 seconds is defined for
a value of 0.
Dimming parameters
Lux level for
regulation
999
150
1-950,
999: disabled Sets a target light level to be maintained by the lighting system
Max value
99%
-
0 to 99%
Maximum dimming output level.
Min value
0%
82%
0 to 99%
Minimum dimming output level.
On value
99%
-
0 to 99%
Dimming output level when switched on (0-99).
Off value
0%
-
0 to 99%
Dimming output level when switched off (0-99). If a non-zero off value is set, the
output will toggle between this value and completely off depending on the switch
level On and Off values. For example, if it is light outside, the fittings will be off if
there is no occupancy. If it is dark outside, they will adopt the preset off value. This
feature is only enabled if “Min value” is set to 99.
Manual control modes
Manual control
mode
✔
-
Shared
2-position
push-button
A single centre-biased retractive switch will be used to control both channels at
the same time.
-
-
Separate
2-position
push-button
-
-
✔
Synchronised
1-position
push-button
A single push-button controls both channels at the same time.
-
-
Separate
1-position
push-button
-
