4
Rev. A
Tool jamming.
•
Burr on end of driver blade, buff burr off driver blade.
•
Magazine obstructed by dirt. Clean magazine, replace if worn.
•
Magazine loose. Tighten bolts VH0032.
•
Pusher damaged. Replace damaged pusher VC4135.
•
Pusher spring(s) weak, damaged or broken. Replace spring(s) VC4132.
•
Damaged driver blade. Replace driver blade VC4101.
•
Worn bumper. Replace bumper VC4119.
•
Worn piston plug. Replace piston plug VC4122.
•
Check fasteners are correct for tool.
Tool fails to cycle.
•
Air supply restriction. Check air lines/compressor. Restrictions can be moisture, dirt, or
hoses and fittings too small for tool volume requirements.
•
Tool dry, lack of lubrication. Use VERTEX air tool oil.
•
Worn valve seal. Replace valve stem seal VC4131.
•
Valve stuck. Disassemble/clean/check/lubricate.
Valve body loosens.
•
Valve body loosens and will not stay in place. Lower bumper has taken a set and
rotates valve body. Replace bumper VC4119.
REPAIR
NOTE:
Mineral spirits is recommended for cleaning tool and parts. Wipe off
immediately, dry parts thoroughly before reassembly, use adequate ventilation.
SAFETY FIRST
– Always disconnect tool from air supply before attempting to clear a jam or
servicing.
NOTE:
Refer to tool schematic and pictures for location of parts and correct part
numbers.
