Leggett & Platt Sleep Comfort, Owner'S Manual

Page: 15 / 24

Sleep Comfort™ Adjustable Base Owners Manual 99301076-b
15
sc-mr2 remote controL Programming
(2 remote controls - 1 base)
The three step procedure below is required to program 2 remote controls to operate 1 base.
Before beginning, make certain the base is plugged into a working grounded electrical outlet.
If
programming fails, initiate the programming procedure a second time.
REMOTE
CONTROL 1
REMOTE
CONTROL 2
OPERATE ONLY ONE (1) REMOTE CONTROL
AT A TIME. OPERATING TWO (2) REMOTE
CONTROLS AT THE SAME TIME WILL
MOMENTARILY BLOCk BOTH RF SIGNALS
AND PREvENT BOTH CONTROLS FROM
FUNCTIONING.
note
steP 2
On remote control 1, simultaneously press and
hold the
PoS 1 and head massage on/off buttons .
The transmission indicator light will flash slowly
and then flash rapidly to indicate programming
mode. Continue to hold for 5 seconds and then
release the buttons ( FIGURE 8 ).
steP 3
Repeat Step 1 and Step 2 with remote control 2.
Two remote controls are now programmed to
operate one base.
steP 1
Locate the power down box for the base and
press the learn button for 1 second and release
(
FIGURE 7
) .
POWER
DOWN BOx
LEARN
BUTTON
FIGURE 7: Power down box learn button.
POS 1
BUTTON
HEAD
MASSAGE
ON/OFF
BUTTON
TRANSMISSION
INDICATOR LIGHT
FIGURE 8