Y-120 K/CK Adjustable Base Owners Manual 290-0089
13
Program Two Remotes to Operate One Base
- Bases
are factory programmed to operate individual
bases. To program two remotes to operate one
base, perform the following numbered procedure.
If programming fails, initiate the programming
procedure a second time.
Program Two Remotes to Operate Two Bases
-
Bases are factory programmed to operate individual
bases. To program two remotes to operate two
bases, perform the following numbered procedure.
If programming fails, initiate the programming
procedure a second time.
REMOTE
CONTROL 1
REMOTE
CONTROL 2
REMOTE
CONTROL 1
REMOTE
CONTROL 2
BASE 1
BASE 2
STEP 1
UNPLUG
the base from the electrical power source
(if plugged in) and wait 3 minutes.
STEP 2
Plug the base into the electrical power source.
You now have 3 minutes to complete the
programming procedure. The programming indicator
(under bed light) will flash to indicate programming
mode.
STEP 3
Simultaneously press and hold the
head up
and
foot up
buttons on
remote control 1
for 2 seconds.
Release both buttons and set remote control 1 aside
without pressing any other button.
NOTE: If
any
button is pressed, base will exit
pairing mode.
STEP 4
Simultaneously press and hold the
head up
and
foot up
buttons on
remote control 2
for 2 seconds.
Release both buttons.
Press the
flat
button, then the
head up
or
foot up
button on
remote control 2
to verify base functions.
Wait 5 seconds and press the
head up
or
foot up
button on
remote control 1
to verify base functions.
NOTE: There should be a 5 second wait time while
switching between remote control 1 and remote
control 2.
Two remote controls are now programmed to operate
one base.
STEP 1
UNPLUG
both bases from the electrical power
source (if plugged in) and wait 3 minutes.
STEP 2
Plug
both
bases
into the electrical power source.
You now have 3 minutes to complete the
programming procedure. The programming indicator
(under bed light) will flash to indicate programming
mode.
STEP 3
Simultaneously press and hold the
head up
and
foot up
buttons on
remote control 1
for 2 seconds.
Release both buttons and set remote control 1 aside
without pressing any other button.
NOTE: If
any
button is pressed, base will exit
pairing mode.
STEP 4
Simultaneously press and hold the
head up
and
foot up
buttons on
remote control 2
for 2 seconds.
Release both buttons.
Press the
flat
button, then the
head up
or
foot up
button on
remote control 2
to verify base functions.
Wait 5 seconds and press the
flat
button, then the
head up
or
foot up
button on
remote control 1
to
verify base functions.
NOTE: There should be a 5 second wait time while
switching between remote control 1 and remote
control 2.
Two remote controls are now programmed to operate
two bases.
REMOTE CONTROL PROGRAMMING
