1. Carefully lift the appliance out of the packaging taking care not to damage the ceramic components in the
separate carton.
2. Remove the magnetic trim and store to one side to prevent any damage.
3. Cut the foam sealing strip (in plastic bag supplied) to length and stick a continuous strip down the two sides
and across the top of the radiant box. When the box is placed against a flat surface the foam strip will form a
seal around the box’s flange.
4. Carefully lift the appliance into position in the fireplace opening and check that the flange of the radiant box
fits flush against the sealing face with no gaps present.
5. Remove the four screws that secure the burner tray to the box, two on the front leg and two at the rear of the
tray. Remove the burner tray and place to one side (Fig. 3).
6. When the burner tray has been removed, decide which side of the appliance the gas supply will be entering
the radiant box and remove the relevant blanking plate (left or right hand side). The gas supply should be
concealed as much as possible.
7. With the radiant box placed in the opening, mark out four of the eight fixing holes. Remove the box and
carefully drill and fit rawl plugs.
8. Pass the 8mm gas connection through the back of the
box and secure the box into place using four screws
(straight shank screws are recommended for marble).
Check that the outer flange of the appliance is completely
sealed against the back panel.
INSTALLATION PROCEDURE
6
Fig. 3
Fig. 4
Burner tray
Blanking plate
Foam Sealing Strip
Magnetic Trim
Fixing
Holes
Fixing
Holes
Fixing Holes
