5.
Function of action
Trigger
Description
Power on
1.
On the network: Send Battery Report , Sensor Multilevel Report. and Wake Up
Notification, LED keeps on 1 second.
Not On the network: LED slow blinks red 3 times and start SmartStart.
SmartStart Inclusion
Add the Door Sensor into the Z-Wave network via SmartStart:
1.
Add Door Sensor DSK into the primary controller SmartStart Provisioning List (If you
don’t know how to do this, refer to its manual, DSK usually print on the main body).
2.
Remove the battery from the Door Sensor. A few seconds later, reinsert battery in the DUT.
3.
The Door Sensor will send “Z-Wave protocol Command Class” frame to start
SmartStart Inclusion.
4.
LED will flash green during the inclusion, and then solid green for 2 seconds to indicate
that the inclusion is successful, otherwise the LED will solid red for 2 seconds in which
you need to repeat the process form step 2
Note:
User should follow the procedure in the section below if the
controller does not support SmartStart inclusion.
