LED Working Light
11230094001020
Instruction Manual
Ledino
LED LIGHTING
the energy saving company
IMPORTANT:
Read all instructions carefully.
Only use the unit as described in these
instructions. Any other use will be deemed as not in accordance with the
instructions and may lead to damage to property or even injury to persons.
The manufacturer accepts no liability for damage caused by use not in accor-
dance with the instructions. If you do not understand this instruction, contact
your dealer. Check the device for transport damage. Those has to be reported
to the forwarder/carrier.
SAFETY:
Danger to life!
The wiring must run according to local statutory regulations and guidelines.
All work must be carried out only by a qualified electrician.
Do not install the light in near of open fire, very hot areas or in humid
environment.
IP20 - no protection against water.
WARNING:
Disconnect power during installation.
These procedures should only be performed by a qualified electrician. Never
perform maintenance or cleaning while electric tension is not de-energized.
Technical Data:
Ledino LED working light with
15 cm cable and quick terminal
220-240 V AC 50/60 Hz / 73 mA, DF 0.7
9 W LED chip, CRI> 80 Ra, SDCM <6
820 lumens, neutral white 4000 K
820 lm corresponds to approx. 60 W bulb light
permissible temp. -15 to 40 °C
220°beam angle, not dimmable
25,000 hours lifetime, 15,000 switching cycles
Alu + PBT housing, PC diffuser
Protection class 2
IP20 - no protection against water
15 cm cable length (2-wire)
Ø: 60 mm H: 100 mm, 0.049 kg
statutory warranty 2 years
Energy class F, 9 kWh/1000
Spitzahornweg 1, 14974 Ludwigsfelde/ Berlin, Germany
Ledino
Deutschland GmbH
the energy saving company
We hereby confirm that the products are in line with the regula-
tions – and in particular with the protection requirements – of
the European Union’s directive on the harmonisation of the legis-
lation relating to electromagnetic compability (2014/30/EU),
the low voltage directive 2014/35/EU, the directive for Energy-re-
lated Products 2009/125/EG and the RoHS directive 2011/65/EC.
Used units must not be disposed of with household waste!
If the unit is no longer operational, every consumer is required by
law to dispose of used devices separate from household waste, e.
g. at a collection point run by the communal authority borough.
In this way, used devices can be recycled and waste materials di-
sposed of in an environmentally friendly manner. For this reason,
electrical equipment is labelled with the displayed symbol.
Disconnect the power supply
for the connecting cable!
Prepare the cable in according
to statutory regulations.
Connect the quick terminals
of the LED working light to
the supply line.
Hang the LED working
light on the hanging loop.
Switch on the power supply.
