Leding XPRESSION 250RGBLA, User Manual

Page: 3 / 12

2
1.2 Safety Notes
IMPORTANT
．．．．．．．．．

This product must be installed by a qualified professional.

In order to maintain this condition and to ensure a safe operation, it is absolutely necessary
for the user to follow the safety instructions and warning notes

The manufacturer will not accept liability for any resulting damages caused by the
non-observance of this manual or any unauthorized modification to the device.
CAUT
．．．．
ION!
．．．．

Make sure that the available voltage is not higher than stated on the rear panel.

Do not touch the power cables if your hands are wet.

The earth wire must always be connected to the ground. Therefore it is essential to connect
the yellow/green conductor to earth.

Make sure that the power-cord is never crimped or damaged by sharp edges. Check the
device and the power-cord from time to time. The electric connection, repairs and servicing
must be carried out by a qualified employee.

Always disconnect power input cable to completely remove power from unit when not in use
or before cleaning or servicing the fixture.

Do not switch the fixture on and off in short intervals as this would reduce the lamp’s life.

Do not touch the device’s housing bare hands during its operation (housing becomes hot)!
The surface of the product’s casing can reach up to 70° C (158° F) during operation. Avoid
contact by persons and materials. Do not install the product in a location where there is a risk
of accidental contact. Allow the product to cool for at least 10 minutes before handling.

For replacement use lamps and fuses of same type and rating only.

Please protect the fixture and avoid destroy during transport and installation. If there is any
damage to the coating, the shell may be corroded.

When hanging lamps and lanterns, it is necessary to verify that facilities and hooks can bear
at least 10 times the weight of lamps and lanterns.

Fix the safety rope at the correct holes only. Only operate the fixture after having checked
that the housing is firmly closed and all screws are tightly fastened.

The maximum ambient temperature 45°C must never be exceeded. Do not operate the
product if the ambient temperature (Ta) exceeds 45° C (115° F).
E
．
lectrical
． ．． ． ． ． ．． ．
W
．
arning
． ． ． ． ．．

The light source contained in this luminaire shall only be replaced by the manufacturer or his
service agent or a similar qualified person