17
and you cannot clear it using these methods,or if the rubber
roll(s) has been damaged or rendered unusable,the roll(s)
should be removed and replaced.you should now consult
your servicing dealer/tech,the Ledco service dept or move
on to the next,Advanced level of troubleshooting/repair.
3)
Advanced.
To remove the rubber rolls(part # 0500-
040.4)and manually free them of wrapped or melted film,or
replace them if they are damaged or unusable, you must
first remove the drive chain,sprocket and rubber roll gears
as described at length previously.Next,using a 1/8”allen
wrench loosen and remove the two ½” shaft collars securing
the top front and rear rollers on the right hand side.Next,
using a 3/16 allen wrench loosen and remove the pressure
bolts and orange pressure springs(part # LC25 031.4)
from the bottom bearing supports(part # 4285 028.4) and
top bearing supports(part # 4285 030.4B).Now,using a 9/64”
allen wrench and a phillips head screwdriver,remove the
cap head screws and button head phillips screws and
stainless steel spacers that hold the top bearing support
cam spring support bar and roller bearing assemblies in
place.You can now slide these top assemblies off the ends
of their respective shafts allowing you to remove the top,
front laminating roller and the top,rear pull roller.Then using
a phillips head screw driver,remove the flat head phillips
screws that secure the bottom bearing supports to the side
panels and slide them off their respective shaft ends.All four
rubber rollers can now be removed and replaced or
exchanged as needed, and reassembled in precisely the
reverse sequence of dis-assembly.The drive system should
now operate smoothlywith no clunking or excessive noises.