4/4
IMPORTANT !
Wrong!
4"
(100mm)
On widest one flat plane (only)
Do not bend sideways.
Flexible on one axis
maximum band radius 4”
TROUBLESHOOTING
Ÿ
Consider testing with a multimeter to ensure light strip is receiving 24V power.
Tape light strip does not light
Ÿ
Have a electrician check all connections and any switch or dimmer connections from the power supply to the LED Light Strips.
LED Flex Strip lights blink on, then go off
Ÿ
Make sure your power supply is turned on and has the correct voltage.
Ÿ
The power supply is not adequate for the length of LED Light Strips you are powering. Install a adequate Class 2 power supply.
LEDs farthest from the power supply are noticeably dimmer
Ÿ
This is the result of voltage drop. Decrease the length of the 24V power feed or use thicker power feed wires between the 24V power supply
and the lighting strips.
Ÿ
Confirm you have the correct polarity (+ to +, G to G, R to R, B to B and W to W) throughout the run of LED Lighting.
MAXIMUM FLEXSTRIP LENGTH SUPPORTED BY LED WORLD’s CLASS 2 POWER SUPPLY
IMPORTANT INSTRUCTIONS
1-800-387-4081
ledworldlighting.com ledworld.ca
|
Copyright © 2022 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.0 - 08/22/22
Power Supply
Max Feet of LED Flexstrips
Power Supply
Max Feet of LED Flexstrips
28.50 Feet (Continuous 77 Watts)
MD-024-096VTDHV2
MD-024-060VTDHV2
17.77 Feet (Continuous 48 Watts)
MD-024-192VTHD52JV2
2 X 28.50 Feet (Continuous 77 Watts
each channel)
MD-024-288VTHD52JV2
3 X 28.50 Feet (Continuous 77 Watts
each channel)
Model
: FC60M51-10M-24V-RGBW
OUTDOOR LONG RUN RGBW LED FLEX STRIP
1
2
3
Apply heat with heat gun to seal
connection. Wire jacket must be
covered by Heat shrink (1/4"") and PVC
cover must be 1/2". RTV Electronics
grade silicone glue to seal.
0.50"
1 ½”long, 3/8” Wide electrical heat
shrink. Note Fig 1. is showing is 2 wire
for single color FlexStrip. RGB FlexStrip
will have 4 wires. Use only RTV
Electronics grade silicone glue over
connections to seal.
Solder wires and place end cap over
wire as in Fig.2. End cap must also be
sealed with heat shrink.
Note : End cap is included in each light kit along with mounting clips. If product is cut, it is no longer water resistant (IP-22)
The following task requires personnel experienced with soldering and low voltage DC wiring techniques.
