OCTOPACK
LECTROSONICS, INC.
6
Control Panel
RF Signal Distribution
Each antenna input is routed through a high quality
RF splitter to coaxial leads on the control panel. Gold
plated right angle connectors mate to the SMA jacks
on SRa Series receivers. Frequencies of the installed
receivers should be within the frequency range of the
antenna multicoupler.
Power Indication
The power switch locks in position to prevent acciden-
tal turn off. When power is engaged, the LED next to
the switch illuminates to indicate the source, remaining
steady when external power is selected and blinking
slowly when the batteries are providing power.
Antenna Power
A recessed switch on the left side of the control panel
enables and disables DC power passed from the
power supply to the BNC antenna connectors. This
provides powering of remote RF amplifiers through
the attached coaxial cable. The LED glows red when
power is enabled.
Receiver Versions
SRa and SRa5P versions of the receiver can be
installed in any combination. Earlier versions of the
receivers with fixed antennas cannot be connected to
the multicoupler antenna feeds, however, the power
and audio connections will still be made via the 25-pin
connector.
Power Status LED
Antenna Power
Switch
