Lectrosonics DM812, Reference Manual, Page: 20 / 51

DM Series Digital Matrix Processors
LECTROSONICS, INC.
20
The LockSet Setup Screen is passcode protected. This
passcode is required to lock or unlock the front panel
controls.
To open the LockSet Setup Screen, navigate to the
TopMenu, use the PRESS FOR MENU/SELECT con-
trol to highlight LockSet, then press the control to open
the LockSet Setup Screen. The LockSet Setup Screen
that opens depends on whether the panel controls have
been locked, or if they are unlocked.
or
⇓
⇓
Entering the Passcode
A passcode is needed to lock or unlock the front panel
controls. This passcode consists of four Item Select
Buttons with the buttons pressed in a preset sequence.
The factory default passcode is 1,2,3,4, corresponding
to the first four Item Select Buttons reading from left to
right. The passcode can be changed, but must always
consist of a sequence of four numerals from 1 to 6 with
each number representing an Item Select Button.
1 2 3 4
The factory default passcode is 1, 2, 3, 4
from left to right.
Press the Item Select Buttons below the display in the
sequence shown at below to enter the default pass-
code.
After the passcode is entered, four symbols will appear
in the upper right section of the screen to confirm the
button presses. Press the PRESS FOR MENU/SE-
LECT control to accept the passcode.
Passcode Item Select Button
confirmation
Locked/Unlock State
If the passcode is correct the LOCKED/UNLOCKED
state will toggle to the opposite state. If the passcode is
invalid an “Invalid” error message will briefly appear.
Changing the Passcode
The unit comes from the factory with a default passcode
of 1,2,3,4. To change the passcode, navigate to the
LockSet Setup Screen. (It does not matter if the front
panel controls are locked or unlocked.)
⇓
Simultaneously press the BACK and Reserved push
buttons to open the Passcode Change screen. You will
be prompted to enter the existing passcode.
PUSH FOR
MENU/SELECT
BACK
Back Button
Reserved Button
Item Select Buttons
⇓