CONFIGURATION 1: Typical End-of- line Cell Installation (With Flow Switch)
Install per diagram below.
Ground Mounting Kit
consists of:
(2) 91.5 cm - 1.9cm x 1.9cm x
.3cm (3' - 3/4" x 3/4" x 1/8")
aluminum angles with four
predrilled 0.156
holes
(4) #10-32 .9 cm (3/8") S.S.
screws. Two for each side
installed within the back-plate
mounting feet.
OPTIONAL GROUND MOUNTING SUPPORT
STEPS FOR INSTALLATION
STEP 1
Choose an adequate location for your LIBERTO Unit Control Panel. Read and follow warnings. Avoid
traffic, lawn mowers and sprinklers. Take both 3 ft (1 m) aluminum angle stakes and drive into ground
approximately 12" (31 cm) deep, to the width of the LIBERTO Unit Control Panel 8 1/8" (21 cm)
(Use a 2" X 4" (5 cm x 10 cm) block and hammer.)
STEP 2
Slide the LIBERTO Unit Control Panel over the angle stakes and screw into the predrilled holes.
CAUTION: DO NOT HAMMER THE LIBERTO UNIT WITH ANY TOOL.
CAUTION:
DRIVE STAKES INTO GROUND BEFORE MOUNTING THE LIBERTO UNIT
CONTROL PANEL.
Continued On Next Page
Above Ground Pool Installation Locations
Appendix
Appendix
17
LIBERT
O
Summary of Contents for 27315
Page 19: ......
