Page 11
LOOM CONNECTION
You should now have:
1 loom with shaft selector installed
1 Solenoid unit
1 Interface Unit (black box)
2 Connection cables
Remove the cover of the solenoid unit.
(Picture here shows the unit installed on the
loom but not yet attached)
Install the solenoid unit using 4 round head
screws #8, 1¼" .
To do that, pass the screwdriver throught the
4 holes made for this purpose. Make sure
you screw in the pre-drill holes.
Solenoide box cover can remain off until you
complete the installation and test the unit.
Make sure that the control box and computer
are turned off and then connect the cables
between:
1)Computer serial (com) port and the
interface box.
2) Interface box and the solenoid unit.
(Female to female cable)
The standard cables supplied are for the PC
Rs232 serial port. For PC lap top you will
need an 9 pin adaptor.
Shaft Selector
Solenoid Unit
