Install metal wire joining the screw hook
of right treadle and screw hook at the
back of the handle.
Chain end’s goes to the treadle screw
hook.
Cable from the treadle have to pass
between shaft frame 2 and shaft frame 3,
then pass in front of the forward inside
pulley to go to the handle hook.
Adjust length of that wire so shed is wide
open (handle in the bottom of the slot)
when treadle is depressed.
IMPORTANT NOTE:
The loom with the stand is designed to
operate with two treadles. The right one
lifts the shafts to open the shed. Never
release right treadle until all shafts are in
rest position then complete the sequence
by pushing the left treadle. It is very
important to depress the left treadle in
order to make sure all shafts are in
neutral and to control the pattern
advance.
SEE ALSO FIRST PICTURE OF NEXT PAGE
Page 9
