WinFast 6300MAX/MA Pro User’s Manual
17
Parallel Port Mode [SPP]
Select an operating mode for the onboard parallel (printer) port. Four modes can be
selected, SPP (Normal), EPP (Extended Parallel Port), ECP (Extended Capabilities Port),
and ECP+EPP. Select Normal unless you are certain that both your hardware and software
support EPP or ECP mode.
ECP Mode Use DMA [3]
This item is available while you set the Parallel Port Mode to ECP mode or ECP+EPP mode.
Game Port Address [201]
Select an address for the game port.
Midi Port Address [330]
Select an address for the midi port.
Midi Port IRQ [10]
If the other device uses the same IRQ with midi port, it will result in your midi port out of work.
Init Display First [PCI Slot]
When select PCI Slot the system will initial the PCI VGA card first. If there are no PCI VGA
cards then the system will initial onboard Super AGP VGA. When select AGP, the system
will initial from on board Super AGP VGA.
System Share Memory Size [16MB]
The memory size shared from system with the size of 2, 4, 8, 16, 32, and 64MB. If the EGM
Support is “Yes”, this item will be shown as 2+2, 4+4, 8+8, 16+16, 32+32, and 64+64MB.
Extend Graphics Memory <WinFast 6300MA Pro does not support this setting item>
If the ADIMM is installed, this item shows the memory size.
4.6 Power
Management
Setup
The Power Management Setup allows you to configure your system to the most effectively
energy saving while in operating.
CMOS Setup Utility – Copyright (C) 1984-2000 Award Software
Power Management Setup
Item Help
ACPI function
Enabled
ACPI Suspend Type
S1(POS)
Video Off Option
Susp,Stby -> Off
Video Off Method
V/H SYNC+Blank
Switch Function
Break/Wake
MODEM Use IRQ
3
Hot Key Function As
Disable
HDD Off After
Disable
Power Button Override
Instant Off
IRQ [3-7,9-15], NMI
Enabled
IRQ 8 Break Suspend
Disabled
Ring Power Up Control
Enabled
MACPME Power Up Control
Enabled
PCIPME Power Up Control
Disabled
KB Power ON Password
Enter
Power Up by Alarm
Enabled
Month Alarm
NA
Day of Month Alarm
0
Time (hh:mm:ss) Alarm
0 0 0
Menu Level
!
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F1:General Help F5:Previous Values F6:Basic Defaults F7:Best Defaults
