If you have any question please, contact [email protected]
2.1
2.2
LL ARC SPOT connecting to ARC dRIvER and dIN POWER SUPPLY
LL ARC SPOT connecting to dIN POWER SUPPLY
dC 24v
max. 10A
POWER
SUPPLY
MW 240
DIN 24V
100-260v AC
Connecting LL ARC SPOT to DIN POWER SUPPLY
enables to switch ON/OFF luminaries.
Connecting LL ARC SPOT to PWM DRIVER and DIN POWER SUPPLY enables to switch
ON/OFF luminaries and in addition intensity and colour control by DMX controller.
DMX
CONTR.
R+
R
- G
+ G
- B
+ B
-
red
green
blue
black
max. 16A
max. 10A!
dC 24v
100-260v AC
connect max. 1,4A per GROUP
RGB
POWER
SUPPLY
MW 240
DIN 24V
Order
code
Product name
I
C
(A)
LL33 700
LL ARC SPOT 19 RGB IP43
3x0,35A
LL33 705
LL ARC SPOT 19 RGB IP65
3x0,35A
04 MAINTENANCE
To tackle all Safety Information- 01!
Damage caused by inadequate cleaning or maintenance is not coverd by
warranty.
Regular cleaning is demand (dust, dirt, ...).
Maintenance policy:
Unplug mains before maintenance and at least 10 minutes cool off
Appliance do not illegal open or demount
Clean-up dust only from outer surface (for ex. diffuser).
Use vacuum or dumpy duster (warm water)
Before reinstalling to check failure-free state – no wet parts!
-
-
-
-
-
-
-
-
03.3.1 Connecting to dC power supply
(Figure Nr. 2.1)
LL ARC SPOT 19 must be connected to the device- MW power supply In:100-260AC/
Out: 24V
It is not necessary to open fixture before connecting to MW power supply.
AC Power Supply Cord plug connections to MW Power Supply:
-
-
Symbol
Pin
Wire Colour
Screw (US)
L
live
brown
yellow or brass
N
neutral
blue
silver
ground (earth)
yellow/green
green
03.3.2 Connecting to LL ARC dRIvER
(Figure Nr. 2.2)
For intensity and colour control is necessary connection with LL ARC DRIVER.
It is not necessary to open fixture before connecting to LL ARC DRIVER.
Before installing of LL ARC DRIVER carefully read USER MANUAL for LL ARC DRIVER.
-
-
-
03.3 Electrical installation
To tackle all Safety Information- 01!
You can suffer a dangerous electric shock by using a high voltage AC/DC
power supply - by touching the AC/DC power supply wires inside LL ARC SPOT 19!
LL ARC SPOT 19 can be operated in two ways:
- 03.3.1 LL ARC SPOT 19 connecting to DC POWER SUPPLY - for switch ON/OFF
luminaries
- 03.3.2 LL ARC SPOT 19 connecting to LL ARC DRIVER - for intensity and colour
control
-
-
-
