Page
1
of
6
FXLD618C2I LED FIXTURE
Version 0.1
OWNERS MANUAL
06/20/2013
www.lightronics.com
Lightronics
Inc.
509
Central
Drive
Virginia
Beach,
Va
234354
757
486
3588
FEATURES AND SPECIFICATIONS
LEDS: 18, 6W each (Warm White, Cool White- 2 in 1)
Beam angle: 25 º
Control system: DMX-512 + Stand Alone Modes
DMX channels: 1/2/3/4/5
DMX connectors: 3 pin XLR
Voltage: 120 VAC 50/60Hz
Max power consumption: 120 Watts
Refresh Rate: > 400Hz
Color Temp.: 3200K - 7000K
Cooling: Internal Fan
Body material: Die Cast Aluminum
Body color: Black
Size: 9.9"L x 9.9"W x 9.1"H (without brackets)
Weight: 10 lbs (4.5kg)
DESCRIPTION
The FXLD618C2I is a warm white, cool white LED
lighting fixture. It is suitable for stage, disco, night
club, and other artistic applications. It has several
stand alone control modes and can operate via a DMX-
512 external signal.
A double yoke enables the fixture to be operated in
several positions.
INSTALLATION
LOCATION
The FXLD618C2I is rated IP20 and is intended for
INDOOR USE ONLY.
Locate the unit in a well ventilated area away from
moisture and heat. Keep the vent holes clear. Holes
are provided on the yokes to install a lighting bar pipe
clamp. Use a safety cable when hanging the fixture.
POWER CONNECTIONS
The FXLD618C2I has a power cable for connection to
a 120 VAC, 15 Amp, 60Hz, service.
THE SAFETY GROUND TERMINAL ON THE POWER
CABLE MUST BE USED.
DMX CONNECTIONS
A system using DMX control should be connected as a
chain of devices. In other words the control signal
cable should proceed from the controller to the first
receiving device and then to others in a continuous
"daisy chain" fashion.
The fixture has a DMX IN and a DMX OUT connector
to be used to connect the chain. The control cable
should NOT be split into a multiple run star
arrangement with a cable running from the controller
directly to each receiving device pack.
DMX CONNECTOR PIN ASSIGNMENTS
There are two different connectors which can be used
for DMX control. They are both XLR type connectors.
Some units use 3 pin connectors. Others use 5 pin
connectors. The FXLD618C2I receives a DMX signal
on the 3 pin MALE connector on one side of the unit.
The 3 pin FEMALE connector is used to connect the
next DMX device on the control chain.
If your console uses a 5 pin connector you can make up
an adapter cable to accommodate this. The following
table shows the pin assignments for BOTH the 3 pin
and 5 pin connectors.
CAUTION
RISK OF ELECTRIC SHOCK
