Warning
When there is a problem with the electric bicycle, it can show error messages. LCD display will show the
icon and an error code will be displayed on the speed display. Error codes are marked from 01 E~FF E; see
their meaning in the table below.
Error code
Description
Solution
1
Communication error
Check the cable connection
2
Regulator protection
Check the three-phase electric line
3
Three-phase supply error
Check the three-phase conncetion
4
Low battery
Charge the battery
5
Brake error
Check the brake connection
6
Turn error
Check the turn connection
7
Hall probe error
Check the hall probe connection
Assembly and disassembly of the wheel with the engine
For transportation and maintenance (replacing the tire tube) it may sometimes be necessary to
disassemble the wheel with the engine.
First, pull lightly to disconnect the engine connector (about 20 cm from the engine entry).
Then loosen the brake (if it is used) and change the gear to the smallest wheel.
Remove the rubber covers from the wheel nuts.
Loosen the engine nut using a spanner size 18 and remove the wheel from the frame.
For assembly, reverse the order of these steps.
To connect the connector properly, the arrows on the connector (1) must face each other.
Switch the drive unit on and test it.
During wheel assembly, pay attention to the proper position of the central axis of the wheel nave facing
down. The cable must enter the engine from below. Otherwise, water could get into the engine on the
cable and the engine could be damaged.
