Leach 2R-II, Operator'S Manual

Page: 37 / 50

OPERATION
SECTION 3
POSITIONING PUSHOUT PANEL
To load the unit, the pushout panel must be positioned
toward the rear of the body.
1. Check the tailgate clamps to make sure both are
securely tightened.
2. Depress and hold the speed-up push button.
3. Push the pushout lever rearward until the pushout
cylinder is fully extended.
NOTE
On units with a telescopic pushout cylinder the pushout
panel is now in position for loading.
4. Release the speed-up button and pull the pushout
lever forward until the pushout cylinder is fully retract-
ed.
5. Repeat steps 2, 3 and 4 until the pushout panel is as
far back as it will go and then pull forward on the
pushout lever to fully retract the pushout cylinder.
Now extend the cylinder a few inches to reset the
clamp.
TAILGATE CLAMPS
SPEED-UP
BUTTON
SPEED-UP
BUTTON
PUSHOUT LEVER
3-12