8. To store an output voltage, press the program button for 3 seconds until all
LEDs go out.
ð
The output voltage is set. To check the set output voltage, repeat step 1.
NOTE!
After 10 seconds, the menu for setting the output voltage disappears
again.
7 Assembly
Notice
Device defect due to the effects of dust and moisture
The effects of dust and moisture can cause device defects
1. Choose a cool, dry and well-ventilated assembly site.
2. Protect the device from the effects of dust and moisture.
To assemble the device, perform the following steps:
ü
Assemble the device on a flat and heat conductive surface.
1. Fasten the device with screws to the 4 lateral holes (Ø 4 mm).
ð
The device is assembled.
8 Installation
To install the device, perform the following steps:
1. Disconnect the starter battery from the on-board supply system.
WARNING!
Disconnect the negative cable first.
2. Secure the positive cable as close as possible to the starter battery with a
suitable fuse (60 A).
3. Connect the positive terminal of the starter battery to the DC input of the
device with a cable (25 mm
2
).
CAUTION!
First connect the charge booster and then the starter battery.
NOTE!
Loosen only the top nut.
9
LEAB Automotive GmbH
Thorshammer 6
24866 Busdorf
LEAB Automotive GmbH
8 Installation
