6 Preparation
NOTE!
If you are using a Clayton Power lithium battery and CAN communica-
tion, there is no need to set the output voltage as it is detected automatically.
Before you install the BPC charge booster, the required output voltage must
be set. To do this, proceed as follows:
Connect the 12 V battery (DC Input)
To connect the starter battery, proceed as follows:
1. Disconnect the starter battery from the on-board supply system.
WARNING!
Disconnect the negative cable first.
2. Secure the positive cable as close as possible to the starter battery with a
suitable fuse (60 A).
3. Connect the positive terminal of the starter battery to the DC input of the
device with a cable (25 mm
2
).
CAUTION!
First connect the charge booster and then the starter battery.
NOTE!
Loosen only the top nut.
4. Connect the negative terminal of the starter battery to the port for the
ground (GND) of the device with a cable (2.5 mm
2
).
ð
The device is ready for operation (‘LED Status’ flashes green).
5. Connect the starter battery to the on-board supply system.
ð
The BPC charge booster is connected to the starter battery.
Setting the Output Voltage
To set the output voltage, proceed as follows:
6. Press and hold the program button for at least 3 seconds until all LEDs light
up.
7. To choose between the output voltages, press the program button.
ð
The LED of the selected output voltage lights up green.
LED Com
LED Failure LED Status Meaning
LED Com: 14.1 V for wet batteries
LED Failure: 14.5 V for gel and AGM bat-
teries
LED Status: 15 V for lithium batteries
Tab. 1:
BPC charge booster output voltages
8
LEAB Automotive GmbH
Thorshammer 6
24866 Busdorf
6 Preparation
LEAB Automotive GmbH
