Le Chai LT895, User Manual

Page: 52 / 72

52
TROUBLESHOOTING
You can resolve many of the problems that may arise without having to call Customer Care Service.
Please try the suggestions below.
PROBLEM POSSIBLE CAUSE
No operation

Check your installation's power supply

Check your circuit breaker

A fuse has blown
Not cold enough

Check the setting temperature
Ambient temperature requires readjustment
of the temperatures

The door is open too often

The door is not closed properly

The door seal is not air-tight

There is not enough space around the
device
No interior light
No display on the LCD screen

Contact your Customer Care Service
There appears to be a loud noise

Check the device levelling

Verify that a piece of paper or part of the
packaging has not remained stuck in the
device.
The door does not close properly

Check the device levelling

The seal is in poor repair

The feet have "moved"
The light (LED) does not come on

The control panel is not working

Printed circuit problem

Mains plug problem

Contact your Customer Care Service
LED display error

Poor display

The temperature value is not shown

Contact your Customer Care Service
The fans are not working

Control Panel to be replaced by your
Customer Care Service
CHANGING DOOR OPENING SIDE
This appliance has reversible doors but is delivered with a right hinged door. The left hand hinge kit
comes with the unit (in the box), should you wish to reverse the hinge on your unit.
For your safety, please unplug appliance before doing this operation.
1.
Incline the wine cooler with 45 degrees, take out right lower hinge’s screws with screwdriver (Fig.1)
2. Lift the cellar and unscrew the upper right hinge with a screwdriver and pull out the door, secure it,
mott and remove the screws, then remove the hinge, place it and screw it on the other side, unscrew
The magnet located at the bottom and center of the frame to install it on the top position of the frame.
Finally turn the door 180 degrees, (Fig.2 & Fig.3 & Fig.4)
3. Take off the decorated nail from left upper side then fit the door with screws then fit the decorated nail
to right side of A location. (see Fig.5& Fig.6)