15
EN
SAVING ENERGY
Inserting a sliding rail (A1.0)
Align the rear clip with the desired hole, push backwards so that
the clip fits completely into the slot (A).
Align the front clip with the desired slot and push down to fit the
clip fully into the slot (B).
Make sure that the rail is stable with the side wall.
Removing a sliding rail (A1.0)
Pull the front bracket upwards to remove the front clip from the
side wall, pull the bracket towards you to remove the rear clip.
Inserting a sliding rack (A1.0)
With the rack tilted (1º), insert it over the rack wheels and slide
into the rails (2º).
Removing a drawer(A1.1)
Remove the bottles from the drawer and also from the rack
above.
Remove the rack
(E)
from the top of the drawer.
Inserting a fixed shelf bracket (A1.2)
Note: pay attention to the positioning, on the right or on the left,
of the brackets.
Align the rear clip with the desired hole, push down to fit the clip
fully into the slot (A).
Align the front clip with the desired slot and push down to fit the
clip fully into the slot (B).
Make sure that the rack is stable with the side wall.
Removing fixed brackets (A1.1)
Pull the front of the bracket (B) upwards to remove the front clip
from the side wall, pull the back of the bracket (A) towards you to
remove the bottom clip.
Installing fixed racks (A1.2)
Place the rack on top of the brackets (1), slide backwards so
that it fits (2).
Maximum weight supported per type of rack.
Caution: Do not exceed the weight indicated in the table
below, to avoid breakage of the wooden shelves.
Install the appliance correctly
SAVING ENERGY
Check the door seals
The appliance should be installed away from sources of heat or
direct sunlight, in a well-ventilated room.
Close the doors
Open your appliance only when strictly necessary - every time
you open the door, more cold air will be lost. The motor will have
to work harder and consume energy in order to restore the
correct temperature.
Set the temperature and humidity*
Observe the recommended ranges, a very high set temperature
or internal humidity value will increase energy consumption.
* Not present in all models.
Respecting the environment
Your appliance does not use any CFC or HCFC gases, the foam
insulation and the refrigerant are harmless to the ozone layer
and do not contribute to the greenhouse effect.
Unpacking
The packaging material is made entirely from recyclable
materials. After unpacking, select and take all unnecessary
materials to the recycling point.
Keep the door seals clean and flexible so that they fit tightly
against the door to ensure that no cold air is lost.
This appliance is marked with the symbol for the selective
sorting of waste electrical and electronic equipment. This means
that this product must be taken to a selective collection system
in accordance with EU Directive 2012/19/EU so that it can either
be recycled or dismantled to reduce any impact on the
environment.
For more information, please contact your local or regional
authority.
Electronic products that have not been selectively sorted are
potentially dangerous for the environment and human health due
to the presence of hazardous substances
This refrigerator contains flammable foaming agents. At the end
of the refrigerator's life, it should be disposed of in an
appropriate place capable of recycling refrigerators. To do this,
contact your local town hall. Under no circumstances should you
dispose of this refrigerator on the public highway.
Fixed racks
(E)
86 kg
Sliding racks
(L)
15 kg
Drawer
(G)
12 kg
