Le Chai LM180, User Manual

Page: 66 / 88

65
USAGE
Starting up the device
Once the wine cabinet is properly installed, we advise that you clean the inside using warm water with a
low concentration of dishwashing liquid. Do not use abrasives or scouring powder; they may scratch the
surface finish.
USAGE
CAUTION! Wine cabinets are intended only for storing and preserving wine.
IMPORTANT: Your wine cabinet is ideally suitable for holding Bordeaux type bottles of 0.75 L capacity. It
can contain larger bottles; however care must be taken that they do not prevent the door from closing
properly.
- When closing the door ensure that it does not touch any of the bottles.
- If you load several bottles at a time, it will take longer before the cabinet reaches the desired
temperature.
-
In order to avoid damaging the door seal, ensure that the door is fully open before moving the
racks along the compartment rails.
Adjusting the temperature
LM 70/LMN70 LM 180/LMN180
“ ”
Button
To control the inner light turn on/off.
(Press this button, the light is on, and the light is not controlled by door.)
NOTE: It will take 3 seconds for LED light completely went out after turning off the light.
In order to reduce energy consumption, this wine cabinet will automatically switch off the LED lights
after 10 minutes.
If you want the LED light to remain on continuously, this is possible. Please press and hold the "
" button for 5 seconds, the display will show "LP".After 4 seconds the display will revert back to
normal and the light will remain on until manually switched off.
If you want to revert back and conserve energy (recommended), please press and hold the " "
button for 5 second, the display will show "LF",after 4 seconds the display will revert back to normal,
and the light will automatically switch off after 10 minutes.
“ ”
Button
To control this appliance turn on/off.
(Press this button, the power is on. Press this button with 3 seconds again, the power is off.)
“ ”
To shows the temperature of the internal cooler.