8
Step 2.7: Reattach the front panel, making sure you don't pinch or bind any wires.
Remember, the black tabs on the edge of the front panel go on the
outside
of the chassis.
Step 2.8: Take a short coffee break; the worst is over.
Step 3: Route the red wire connected to the OT-11P through the notch in the radio's center-right
shield panel, to the front right compartment of the radio. Locate the small circuit board there, and
the black multi-pin connector on the left side. Locate the two pins closest to the back of the radio.
Carefully tack solder the end of the red wire from the OP-11 to either or both of these pins. Check
your work and make sure there are no solder bridges to the adjacent pins.
