8
FOCUS AND MIRROR ADJUSTMENT
FOCUS AND MIRROR ADJUSTMENT
FOCUS AND MIRROR ADJUSTMENT
FOCUS AND MIRROR ADJUSTMENT
FOCUS AND MIRROR ADJUSTMENT
fig. 4
GOBOS REPLA
GOBOS REPLA
GOBOS REPLA
GOBOS REPLA
GOBOS REPLACEMENT
CEMENT
CEMENT
CEMENT
CEMENT
To do this operation, it is suggested to use two GOBOS with patterns superinposition (i.e. GOBO B “ROTATING
GOBO wheel” + GOBO B “FIXED GOBO wheel”).
FOCUS ADJUSTMENT
To focus do as follows:
•
loosen the knob placed on the objective (fig. 4);
•
move the objective forwards/backwards to reach the best focus;
•
fasten the knob.
MIRROR ADJUSTMENT
It is possible to orientate the mirror housing, turning it of 180° right/left. To do the above mentioned operation it is
necessary to:
•
loosen the two knobs placed on both sides of the objective, using a cross screw driver (fig. 4);
•
orientate the mirror housing until the preferred position is reached;
•
lock the two knobs.
It is also possible to remove the mirror housing. To do the above mentioned operation it is necessary to:
•
unscrew the focus regulation knob;
•
loosen the two mirror regulation knobs;
•
disconnect the connector, unscrewing the appropriate bush (fig. 4);
!
ATTENTION: disconnect/connect the connector only when the projector is Off.
•
take off the mirror housing;
•
screw the focus regulation knob.
To assemble again the mirror housing, do the above mentioned instructions in the opposite direction.
OBJECTIVE
MIRROR
REGULATION KNOB
FOCUS REGULATION
KNOB
BUSH
CONNECTOR
SC-12/R
CODE 991247
To replace the GOBOS is extremely simple:
1) Disconnect the projector from the power supply;
!
In case it has been recently used, make sure that has cooled down.
2) Unscrew the locking bolt of the rear panel of the projector and take out the top cover (fig. 3, page 7);
3) Keep stopped the rotor and softly take out the spring using a pointed object;
4) Replace the GOBO and softly take back the spring.
!
Never push on the GOBO to take out the spring, to avoid damaging the same GOBO and/or the rotor.
