ITALY
SC-12/R HMI 1200
230
1300
55/02
Hz
Amp.
Lamps
Max. Temp.
50
10
S.R.L.
SPEC.
50°C
HMI 1200
fig. 2
6
BEFORE USING THE PROJECTOR
!
Carefully read the precautions on page 3 before installing the projector.
In particular read the following points:
1) Disconnect the power supply before replacing the lamp or doing any maintenance job.
2) Do not open the projector if are not passed at least 5 minutes after it went off.
3) Always wear protective gloves and goggles to replace the lamp or to work inside the projector.
4) The protecting screens, the lenses and the ultra-violet filters must be replaced if visibly damaged.
Slits or deep cuts remarkably reduce their efficiency.
5) To avoid any bad performance of the projector or that the lamp breakage could damage its optic,
replace the lamp as soon as it reaches its average life time (750 hrs).
6) Periodically clean the in/out air grates.
7) In case the projector must be held on a structure (truss), make sure that it is well and safely fixed,
even using a safety chain from the projector to the structure.
8) Do not install the projector outdoors, directly exposed to rain and moisture.
9) Before connecting the projector to the main power supply, make sure that the working voltage and
frequency correspond to the values indicated on the label (fig. 2).
The SC-12/R is supplied to work at a working voltage of 230V 50Hz (60Hz on request); 10A.
For being supplied with a voltage of 100-120V it is absolutely necessary an auto-transformer with
the following characteristics:
• Output voltage 230V.
• Output current 11A.
10) The connection of the projector to the mains is described in fig. 2/a:
10 a) Do not install the projector close to heat sources. Do not lay the connection cables on the
projector when it is hot.
10 b) The unit must be placed where it could be easily aerated. To avoid obstructing the in/out air
gratings.
10 c) The projector must be distanced almost 0,3 mt. from walls or any inflammable surface
and almost 1mt. from lighted objects.
The unit must be connected to the earth. The inobservance of these
instructions automatically makes the guarantee expiring.
CONNECTION T
CONNECTION T
CONNECTION T
CONNECTION T
CONNECTION TO THE POWER SUPPL
O THE POWER SUPPL
O THE POWER SUPPL
O THE POWER SUPPL
O THE POWER SUPPLY
Y
Y
Y
Y
IMPORTANT
!
POWER SUPPLY INPUT
SC-12/R
CODE 991247
fig. 2/a
L = PHASE (Brown)
N = NEUTRAL (Blue)
= EARTH (Green - Yellow)
THREE POLES FEMALE CONNECTOR
FOR THE CONNECTION TO THE MAINS
L
N
