8
DEUTSCH
FRANCAIS
ESP
AÑOL
ENGLISH
IT
ALIANO
POLSKI
18
ST RETURN
Volume controller for the stereo line input ST RETURN (N 17). The ST RETURN signal is mixed directly into the sum channel MAIN MIX.
Turning the controller to the right increases the volume and turning it to the left decreases it.
19
PHONES
Headphone connection with 6.3 mm stereo jack. Output of the sum channel signal MAIN MIX. The volume can be adjusted via the PHONES /
CTRL controller (N 21) and is independent of the volume of the MAIN MIX volume controller. Use headphones with a minimum impedance of
30 ohms and make sure that the volume stays at a pleasant level, in order to avoid hearing damage caused by loud noise.
20
CTRL OUT L / R
Unbalanced stereo line output with 6.3 mm jack sockets to connect active monitors etc... Output of the sum channel signal MAIN MIX. The
volume can be adjusted via the PHONES / CTRL controller (N 21) and is independent of the volume of the MAIN MIX volume controller.
21
PHONES / CTRL
Volume controller for the stereo line output CTRL (N 20) and the headphone output PHONES (N 19). When using headphones, make sure
that the volume stays at a pleasant level in order to avoid hearing damage caused by loud noise.
22
2 TK IN
Unbalanced stereo line input with RCA sockets for connecting an external audio source with line level (e.g. MP3 player).
23
2 TK IN LEVEL
Volume controller for the stereo line input 2 TK IN (N 22). Turning the controller to the right increases the volume and turning it to the left
decreases it.
24
2 TK IN TO MAIN / TO CTRL
This switch allows to route the incoming signal of the stereo line input 2TK IN either to the stereo line output MAIN MIX OUT (not pressed
down = TO MAIN), or to the stereo line output CTRL OUT and headphone output PHONES (pressed down = TO CTRL).
25
MAIN MIX OUTPUT
Unbalanced stereo line output with 6.3 mm jack sockets to connect an active PA system. Output of the master signal of the mixer.
26
2 TK OUT
Unbalanced stereo line output with RCA sockets for connecting an external recording device (e.g. laptop). Output of the master signal of the mixer.
27
MAIN MIX
Volume controller for the stereo line outputs MAIN MIX OUT (N 25) and 2 TK OUT (N 26) Press the Fader button upwards to increase the
volume, and downwards to decrease it. Before you turn on the power of the connected PA system, set the volume controller to minimum.
28
OUTPUT LEVEL
2 x 8-segment LED level display for visualising the volume level of the stereo sum channel. To avoid distortion, reduce the volume level of
the output channel as soon as the red CLIP LED lights up.
29
AUX SEND
Unbalanced mono line output with 6.3 mm jack sockets to activate an external effects device (POST Fader).
30
+48V ON / OFF
+48 V phantom power supply for operating high-quality condenser microphones without own power supply. Press down to select the ON
position (red LED light is on) to turn on the phantom power for the XLR microphone inputs, and return to the original OFF position to turn
it off (red LED light is off). Turn on the phantom power only after connecting a microphone, or off after disconnecting, and set the volume
controller of the channels 1 to 4 to minimum before this step.
