LD LAX8D, User Manual

Page: 13 / 104

13
BACK
PANEL:
28 POWER ON/OFF SWITCH
This switch is used to turn the Main Power ON and OFF.
29
AC INPUT CONNECTOR
This connector is used to connect the supplied AC adapter.
30
PHANTOM ON/OFF SWITCH
This switch will apply +48 Volt Phantom Power only to the 6 XLR inputs sockets. When these XLR sockets are
connected with devices that do not require Phantom Power, please make sure the Phantom Power is turned
off, otherwise, this may damage the device and mixer.
31 MAIN MIX OUTPUT
The stereo output is supplied both XLR and 1/4“ TRS sockets, which are used to send the audio signal to an
amplifier. Through the main mix level control, you can adjust the output level from - to +15dB.
32 CONTROL ROOM OUTPUT
These 1/4“ phone sockets will be used to send the signal to studio monitor speakers or to a second set of
PA.
33 INSERT
Insert sockets are provided for each mono MIC channel. It can allow you patch external signal processing
devices into signal path via a TRS connector, the signal will be taken out after the input gain control (TRIM),
and sent to an external processor such as a compressor-limiter, then returned into the same channel
immediately before the EQ section.
Note: Usually, insert connections require a special stereo-splitting Y-cord to be connected, known as TRS
connector (Tip Send/Ring Return).
INSERT INSERT INSERT INSERT
LEFT RIGHT
R
CTRL ROOM OUTPUT
4 3 2 1
L
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: SHOCK HAZARD
AVIS: RISQUE DE CHOC ELECTRIQUE
- DO NOT OPEN
- NE PAS OUVRIR
POWER
ON OFF
PHANTOM
AC INPUT
R
L
MAIN MIX OUTPUT(BAL/UNBAL)
SERIAL
MODEL
30
29 31 32 33 28
ENGLISH
DEUTSCH
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
ESP
AÑOL
POLSKI