IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
9
24
25
28
23
28
26
19
19
27
27
26
17
RELEASE BUTTON
Push a CURV 500 satellite from behind onto the SmartLink® adapter as far as it will go while keeping the spring-loaded release button at
the side of the satellite pressed down. In doing so, make sure that the two guidance rails of the satellite (18) are correctly fitted into the
grooves (19) on the top of the SmartLink® adapter or lower satellite so as to ensure a solid fit and to establish a connection between the
contacts of the two components. Now release the button back into its original position so as to lock the connection. Proceed in the same
way to expand the system with additional satellites.
18
GUIDANCE RAIL – LD CURV 500 (TS) SATELLITE
19
GROOVES – SMARTLINK® ADAPTER OR LD CURVE 500 (TS) SATELLITE
20
M3 THREAD
M3 thread for securing the LD CURV 500 satellite for permanent installation.
21
LOCKING SYSTEM
22
CONTACTS
23
SATELLITE 1/2
Flange for one to two single satellites or one double satellite (upright position).
24
SATELLITE 3–6
Flange for three to six satellites (forward tilt position; here one double satellite is equivalent to two single satellites).
25
INPUT SIGNAL
speakON-compatible speaker input. The speaker input INPUT SIGNAL (25) is wired in parallel with the terminal block socket (26).
26
TERMINAL BLOCK SOCKET
Terminal block socket for permanent installation and desktop use (terminal block connector supplied).
The speaker input INPUT SIGNAL (25) is wired in parallel with the terminal block socket (26).
27
M6 THREAD
M6 thread for attaching the truss mounting adapter LDCURV500TMB.
28
M6 THREAD
M6 thread for attaching the safety eyelet (ring bolt) for truss mounting.
