Liquid Combustion Technology, LLC Engines Manual
17
rev. 03/29/12
STORING YOUR ENGINE
Storage Preparation
Proper storage preparation keeps your engine trouble-free and clean. The following
steps will assist in keeping rust and corrosion from impairing your engine’s function and
appearance, and will make the engine easier to start when using again.
Cleaning
If the engine has been running, allow it to cool for at least half an hour before cleaning.
Clean all exterior surfaces and apply a light fi lm of oil or WD-40 to prevent rust.
• Do not spray water into muffl er or air cleaner. Water in the air cleaner will soak the air
fi lter, and water that passes through the air fi lter or muffl er can enter the cylinder and
cause severe damage.
• Water contacting a hot engine can cause damage. If the engine has been running,
allow it to cool for at least half an hour before washing.
Adding a Fuel Stabilizer to Extend Fuel Storage Life
1. Turn the fuel valve off while engine is running and allow the engine to run
until it stops. Turn engine OFF when it begins surging to avoid engine damage.
2. Add fuel stabilizer, following the manufacturer’s instructions.
3. Turn fuel valve on after adding fuel stabilizer
4. Re-start engine.
5. Run the engine outdoors for 1 minute to be sure that treated gasoline has replaced
the untreated gasoline in the carburetor.
6. Slow the engine to an idle speed. (Non-generator application.)
7. Repeat step 1 above.
Helpful Tips & Suggestions
