2 ET60 Installation and Operating Instructions
1) Unlock the front cover of the meter and lift
upwards slightly and away from the wall bracket
(see Figure 2). Unplug the cover flying lead from
the wall bracket and remove front cover.
2)
The ET60 should be mounted on a smooth
vertical wall making sure access to the side coin
entry is not obstructed. Take care to mount the case
level in both the vertical and horizontal axes;
failure to do so may prevent the coin mechanism
from operating correctly. M
ark positions of the
mounting holes using the wall bracket as a
template and drill suitable holes in the wall. For
solid masonry use a 7 mm masonry drill bit and
plug holes with wall plugs sufficient for 38 mm
long screws. For wooden surfaces use a 3.5 mm
drill bit and screws of a minimum length of 15
mm; longer screws are advised for very soft
surfaces. Fit the top two screws to the wall leaving the head of the screw
approximately 7 mm from the surface. Hang the wall bracket on the wall, check that
the bracket is level and tighten the screws. Fix the bottom of the wall bracket to the
wall using the two remaining screws.
3)
The timer will require a fused double
pole switch for the mains input. Wire the
unit as shown in Figure 3 using
appropriately rated and approved cable
conforming to the relevant regional
standards.
The meter can either be
connected to the supply via a cable fed
through the hole at the bottom left hand
side of the wall bracket or through the
back of the meter. Ensure the cables are
secured underneath the cable clamps.
4) Plug the flying lead from the cover to
the connector located in the wall bracket
and fit the front cover onto the wall bracket, drop down slightly and lock into place.
5)
Apply power and the meter will briefly show ‘Pxx.x’ then any credit remaining
where xx.x is the version number of the firmware and should be quoted if requesting
technical assistance.
IMPORTANT: PROTECT THE INPUT BY A FUSE RELEVANT TO THE LOAD
Figure 3 Wiring Diagram
Installation
Figure 2 Removing Cover
Front
cover
Wall Bracket
E
L
N
MAINS IN
R/L
LOAD OUT
