LAZER BULLET 2.0
The Lazer Bullet 2.0 helmet can
accept the
LifeBEAM sensor
to
measure your pulse rate when riding.
This system can connect via
Ant+
or
Bluetooth
to any device you want to
use during riding, so you can always
monitor your pulse rate
throughout
the ride.
A)
To install the
LifeBEAM sensor
first snap the LifeBEAM accessory
mount (
4A
) into the helmet, by
pushing the mushroom install mounts
into the snap baskets located at the
rear of the helmet.
B)
Once this accessory mount is
installed, attached the LifeBEAM
sensor box to this accessory by
looping the rubber sensor housing to
the accessory mount attached to the
helmet.
C)
Then install the sensor in the
front of the helmet, where it can
make contact with the skin on your
forehead. When this is done, run the
cable through the helmet towards
the back, and attached the cable
to the sensor box using the the jack
attached to the cable and the socket
foreseen in the sensor box.
Switch on the Sensor box, connect a
device to the sensor box via
Ant+
or
Bluetooth
signal, and put the helmet
on your head. After 10 seconds you
should start seeing your pulse rate on
your device and you are ready to go.
Please read the LifeBEAM manual
for more detailed instructions.
4. How to install the LifeBEAM Sensor?
4
4B)
4A)
4C)
