2
2. How to customize your Bullet 2.0?
The Lazer Bullet 2.0 helmet has the
option of being customized with
another decorative cap on top of the
helmet (
2B
).
A)
To change this cap, close the
Airslide system as shown in
1B
.
Then reach inside the helmet and
push with your fingers on the Airslide
cap through the front ventilation hole
on the helmet, this should release the
Airslide cap from the helmet.
B)
Now grab the cap covering the
back of the helmet with two fingers on
the part that says LAZER and gently
pull it away from the helmet towards
the rear.
C)
To install a new cap, place the new
cap aligned with the free space on
top of the helmet and gently press
downward until you hear a popping
sound.
Then align the Airslide cap with the
opening in the helmet and gently
apply pressure until you hear a
popping sound.
Make sure that both caps are installed
correctly and that the caps align
perfectly with the helmet, apply more
gentle pressure if needed.
Attention: Always install both
caps on the Bullet 2.0 before use.
Lazer does not recommend using
the helmet without these caps
installed.
LAZER BULLET 2.0
2A)
2C)
2B)
