25
For HELP, call La-Z-Boy
®
Spas at 1.800.465.2933.
CAUTION:
If water does not flow from the jets after 2 minutes, turn pow-
er off at the main panel and bleed air from the system (see
page
35
). Turn power on again. Sometimes momentarily
turning a pump off/on will prime it. Only do this four times
.
6) Plug in the spa or turn on the circuit breaker. Set the desired temperature by using
the up or down keys.
7) Push the jet button on the keypad to turn on the low speed pump. Check to ensure
water is coming from some of the jets. If the water is not flowing out, open the air
bleed valve slightly to release trapped air. Close the valve when the pump pushes
water out of air bleed. Push the jet button on the keypad and the pump will turn on
high speed. Observe closely to ensure adequate water flow.
8) Re-attach the equipment access panel.
9) Heating will occur at a rate of approximately 5-12ºF or 3-5ºC per hour.
10) Ensure proper water chemistry is necessary only after completing the above steps.
11) To conserve energy and ensure your spa / hot tub is ready for use, place the col-
or coordinated cover securely on the spa.
