LawnMaster PB Series, Safety And Operating Manual

Page: 19 / 34

19
A STEELFORT PRODUCT | STEELFORT.CO.NZ
2. GENERATOR MAINTENANCE
• Make certain that the generator is kept clean
and stored properly.
• Use a damp cloth to clean exterior surfaces of
the generator.
• Use an compressed air (25 PSI) to clear dirt
and debris from the generator.
• Inspect all air vents and cooling slots to ensure
that they are clean and unobstructed.
WARNING
• DO NOT use water to clean the generator. Water
can enter the generator through the cooling
slots and damage the generator windings.
• DO NOT modify the generator in any way.
• DO NOT tamper with governed speed.
Generator supplies correct rated frequency and
voltage when running at factory set.
• Tampering with the factory reset governor will
void your warranty
3. ENGINE MAINTENANCE
3.1 ENGINE OIL
LawnMaster 10W30 Oil (PP01020005) is
recommended. Other viscosities shown in the chart
may be used when the average temperature in your
area is within the indicated range. OIL MUST BE
PLACED IN ENGINE BEFORE STARTING.
Ambient Temperature
Oil capacity (rated):
See Parameters.
3.2 ADD OIL
1. Place the engine on a level surface.
2. Remove the dipstick and wipe it clean.
3. Add recommended oil to the upper limit.
CAUTION
3.4 OIL LEVEL CHECK
Reinstall dipstick into tube; rest on oil fill neck, DO
NOT thread cap into tube.
4. Fully tighten the dipstick.
5. Dispose of used oil at an approved waste manage-
ment facility.
3.5 CHANGE OIL
CAUTION
Change oil when the engine is warm from operation.
1. Place the engine on a level surface.
2. Clean area around dipstick and drain plug.
3. Remove oil dipstick.