10
A STEELFORT PRODUCT
•
Remove the spark plug cap.
•
Wait until the engine is sufficiently cold.
•
Never dispose of oils, fuel or other polluting
materials in unauthorized places.
Before performing any maintenance or cleaning
work, always turn off the engine.
1.
Do not spray the unit with water. Ingress of
water
2. Clean the unit with a cloth, hand brush, etc.
MAINTENANCE SCHEDULE
Expert inspection is required:
•
If the grass trimmer strikes an object.
•
If the motor stops suddenly
•
If the nylon cutter is damaged
•
If the internal gears are damaged.
Always clean and rewind the nylon spool at the end of
the trimming season. Always clean the nylon spool or,
if required, replace the spool. Always have the nylon
spool cleaned or replaced by a qualified LawnMaster
Service Dealer.
CLEANING THE ENGINE
To reduce the risk of fire or overheating, periodically
clean the cylinder fins and air vents with compressed
air and clear the silencer area to get rid of dust,
branches, leaves or other debris.
GENERAL INSPECTION
Periodically check that all the nuts and screws are
securely tightened and the hand grips are securely
fastened. If you notice signs of wear on the starting
cable, contact your dealer for a replacement. Fre-
quently check for and replace any damaged parts.
CLEANING & CHANGING SPARK PLUG
•
•
Periodically remove and clean the spark plug
using a metal brush to get rid of any deposits.
•
Check and reset the correct distance between
the electrodes.
•
Replace the spark plug and fasten it firmly
using the supplied wrench.
•
The spark plug must be replaced by one with
the same characteristics whenever the elec-
trodes have burned or the insulation has worn,
or every 100 working hours.
5. Continue to wind the line until you have 150mm
of line left on each end. Note: It is helpful to
clip and fasten the line on opposite
ends of the spool to keep the line from
unraveling during the next step.
6. Put the spool into housing. Unclip the line
from the spool and place line through the open
eyelet on opposite ends of the housing. Ensure
the line has not tangled.
7. Clip the housing back onto the line trimmer
MAINTENANCE & STORAGE
It is the operator’s responsibility to complete all
scheduled maintenance and or servicing in a timely
manner. Always correct any issues before operating the
line trimmer. Follow all inspection and
maintenance recommendations that are listed in the
manual.
WARNING
Improper maintenance and or failure to correct
problems prior to operating the unit may cause the
unit to malfunction and result in property damage and
or serious personal injury. Improper maintenance and
servicing may void warranty.
During maintenance operations:
12 hours of use
24 hours of use 36 hours of use
Air Filter
Clean
Clean
Replace
Spark Plug
Clean
Clean
Replace