9
HANDLEBAR FOLDING INSTRUCTIONS
•
Attach the handle bars to the mower using the
bolt and screws provided.
•
Once the handle bars are in position, attach the
screws with the lever knob facing out.
Note: You may require a crescent or 13mm spanner.
for the next step to tighten the nut.
•
Tighten the nut and ensure the washers are in
correct position, see Image A. Small washer
with bolt, big washer with locking knob.
•
Lock the handlebar in mowing position by
activating the locking lever. To change the
handlebars back to the storage position, simply
loosen the handle locking lever and rotate the
upper handlebar forward over the mower body.
Handlebar Height Adjustment
The height of the handlebar can be adjusted. Lift the
grass flap and secure it in open position, loosen the
four bolts two on each side connecting the handle to
the mower.
•
The handle can now be adjusted to the correct
height by moving it. Hold the handle in place
and tighten the bolts to secure the handle in its
new position
ASSEMBLING THE GRASS CATCHER
1. Place the base of the catcher
onto a flat surface.
2. Tilting the top of the catcher
forward - ease onto the base.
Locate the front lugs and tilt
carefully rearwards to align
the remaining lugs.
3. Ensure both halves are aligned
and the lugs engaged. Clamp togeth-
er the top and bottom halves (with
firm pressure) to lock securely.
INSTALLING THE GRASS CATCHER
•
Lift the rear flap (1).
•
Lift the grass catcher by its handle (2) and
place under the rear flap so that the hooks (3)
on the grass catcher are seated on the door
rod (4).
•
Release the rear flap. When installed correctly,
the hooks on the grass catcher will extend
through the openings on the rear flap.
NOTE: When using the grass catcher, do not install
the mulching plug.
FITTING & REMOVING THE MULCH PLUG
•
Stop the engine.
•
Make sure the discharge chute and underside
of the mower is clean
•
Lift the rear flap of the lawnmower and remove
the catcher, if fitted.
•
Grasp the mulch plug by its handle and insert
into the rear of the lawnmower ensuring it is
positioned correctly.
•
Guide the mulch plug in over the rear axle and
crossbar and then clip into position.
•
Lower the rear flap and clip over the protruding
section of the mulch plug.
•
The mower is now ready for mulch.
•
To remove the plug, press down on the handle
of the mulch plug and lift the rear flap of the
lawnmower.
Image A
Small Washer
Big Washer
