OPERATION
25
BUCKING WITH A WEDGE
(See Fig. 16)
If the wood diameter is large enough for you to insert a soft bucking wedge without touching the
chain, you should use the wedge to hold the cut open to prevent pinching.
BUCKING LOGS UNDER STRESS
(See Fig. 17)
side. As you cut the log, it will tend to bend. The saw can become pinched or hung in the log if
under stress to prevent the bar and chain from pinching.
OVERBUCKING
(See Fig. 18)
Begin on the top side of the log with the bottom of the saw against the log; exert light pressure
downward. Note that the saw will tend to pull away from you.
UNDERBUCKING
(See Fig. 19)
Begin on the under side of the log with the top of the saw against the log; exert light pressure
upward. During underbucking, the saw will tend to push back at you. Be prepared for this
Fig. 16
Fig. 17
Fig. 18
Fig. 19
WEDGE
LOAD
1ST CUT 1/3 DIA
OVERBUCKING
1ST CUT 1/3 DIA
FINISHING CUT
UNDERBUCKING
FINISHING CUT
LOAD
LOG SUPPORTED AT ONE END
LOG SUPPORTED AT BOTH ENDS
Summary of Contents for CS1216
Page 43: ...43 EXPLODED VIEW PARTS LIST...
Page 45: ...45 NOTES...
Page 87: ...87 VUE CLAT E LISTE DES PI CES...
Page 89: ...89 REMARQUES...
