26
HEAD LINE REPLACEMENT
Follow the instructions for replacing the nylon line.
1- Firmly hold the body of the cutting head and unscrew the bumper cover.
2- Remove the empty spool. Remove the line remaining on the spool.
3- Remove the spring.
4- Clean the interior of the spool body carefully.
5- Take a length of 5,40 m nylon line of 2,4 mm diameter or less, in special plastic,
suitable for trimmer and fold into two equal length (2,70 m each).
6- Place the two pieces of the nylon lines in the central interstice of the spool,
designed for this purpose.
7- Wrap, in the direction of clockwise (follow the direction of the arrow
“Wincord” engraved on the spool), the 2 nylon lines in their respective
compartments.
8- Fix the 2 ends into two of the 6 notches of the lower flange of the spool, leaving
about 150 mm beyond the slot.
NB:
The notches are of different sizes to better fix the nylon line in function to its
diameter.
ATTENTION:
Once engaged, the lines must be diametrically opposite, i.e. face to
face.
9- Put again the spring in place on the spool filled.
10- Pass each line into an eyelet of the cutting head and pull on each line
alternatively, while maintaining pressure on the nylon spool.
11- Put again the bumper cover and screw.
Be sure that the cover is properly closed.