6.
Turn the dial to the OFF position for longer than 2 seconds to
discontinue the manual program cycle. (Always return dial to
RUN position to enable automatic operation.)
Manual Valve
Use this feature to start one or more valves watering sequentially
for a selected period of time.
To Select Valves for Timed Manual
1.
Set the dial to the MANUAL VALVE position.
2.
3.
The valve 1 A will flash. You may use the + and - buttons to
select the amount of time for valve 1 to water or skip to the
next desired valve by pressing the
button.
Select the valves to water and their watering duration by
repeating step 2 for the remaining valves.
4. Set the dial to the RUN position. Valves will water sequentially
for the set time with the operating valve’s A blinking during its
manual watering operation.
5. Turn the dial to OFF position for longer than 2 seconds to
discontinue the manual valve program. (Always return dial to
RUN position to enable automatic operation).
Note:
You may advance through a running cycle by pressing
the
key to skip any undesired valve(s).
V. Installation
Selecting an Installation Site
Install the controller with the display at eye level. The controller
must be mounted at least 15 feet away from your pump
start relay and pump. Do not plug the controller into any
power circuit serving a refrigerator, a pump or an air
conditioner.
WARNING:
This controller is designed for indoor installation
only. Installing this controller outdoors will void the warranty
and may result in an electric shock hazard.
Mounting the Con troller
1.
Determine mounting height and center position. From this
location mark a point 2 l/4” (57 mm) to the right and 2 l/4”
(57mm) to the left. Drive a screw into the wall at each point
leaving approximately l/8” (3mm) of the screw exposed. Hang
the controller on the two exposed screw heads.
2.
To secure the controller, remove door and drive the third screw
through the bottom mounting hole in the controller.
Summary of Contents for Lawn Dial LD-4
Page 1: ......
