To set the start times for Program B
NOTE: Skip this step if all Zones will be set to run
on the same day. using the same start times.
Simply place all Zones in Program A.
A. Press
B. Press
and hold until display shows the desired
hours and A (AM) or
C. Press
and hold until display shows the
desired minute (minutes advance in increments of 5).
D. Repeat Steps A through C to set additional start times
for all Zones in Program B.
E. Press
to return to clock mode.
NOTE: Since all Zones on a Program water
in sequence, beginning with the lowest numbered
Zone, make sure all Program start times are far
enough apart to prevent watering cycles from
overlapping. If overlap occurs, the controller will
automatically delay the next start time to allow
completion of the current watering cycle.
A watering cycle that runs past midnight will
cancel any overlapping start times before midnight.
Setting the watering run time-how long to water
Your controller gives you a wide range of run times to
provide precisely the right amount of water to each Zone.
Run times may vary from 1 to 99 minutes.
Set Program A Zones
A. Press
once to display
This indicates
Zone1 is set to run for 5 minutes on the days assigned
to Program A.
B. If you want Zone1
to remain in Program A, press
until the desired run time appears. Display will increase up
to 99 minutes, and begin counting again from one minute.
C. To prevent Zone1
from watering in Program A,
press
to display
D.
Continue pressing
and repeating Steps B
and C until all Zones have been set to the desired run
_ _ _
times or to
E. Press
to return to clock mode.
Set Program B Zones
A. Press
once to display
This indicates
Zone 1 is not set to run in Program B.
B. To make the Zone water in Program B instead of A,
press
and
until the desired run time appears.
Display will begin counting again from 1 minute after
reaching 99.
C. To keep the Zone from watering in Program B (and
leave it active in A, if so programmed), press
D. Continue pressing
and repeating steps B and C
until all Program B Zones have been set to the desired run
times or to
E. Press
to return to clock mode.
12
IMPORTANT You must set all Zones that are
not connected or that you do not wish to water Do
this
pressing
repeatedly until each Zone
number to be set
to appears, then press
until display indicates
Repeat this sequence
using
for all unused Zones in Program B.
13
